Drivetrain
for Surron Light Bee X
Drivetrain verified to fit the Surron Light Bee X (60V 38.5Ah). Every part below carries the SLBX fitment tag, checked before it ships. See everything for the Surron Light Bee X.
Verified FitWarp 9 Sur-ron Drive Chain
Verified FitWarp 9 Warp Drive
Verified FitChain Guards Cover Protection for Sur-Ron
Verified FitChain Guards Fit Sur-Ron Light Bee
Verified Fit
Rear Sprocket for Sur-Ron Light Bee
Verified FitDirtyBike 219 Primary Drive Replacement Chain
Verified FitDirtyBike Aluminum Axle Blocks
Verified FitDirtyBike 420 Final Drive X-Ring Chain
Verified FitDirtyBike Surron LBX E-Ride Pro 420 Primary Drive RK MXU Sealed Replacement Chain
Verified FitDirtyBike Surron LBX E-Ride Pro 420 Primary Drive Sealed X-Ring Replacement Chain
Verified FitDirtyBike Surron LBX E-Ride Pro Primary Drive Replacement 219 Rear Driven Sprocket
Verified FitDirtyBike Surron LBX Final Drive Front Sprocket, 14T
Verified FitOEM Complete Jackshaft Assembly — E-Ride Pro & Surron
Verified FitSurron LBX / Segway Jackshaft Pulley (Belt Drive)
Verified FitPrimary Drive Pulley for Surron LBX and Segway (Motor Pulley, Belt)
Drivetrain questions, answered
What does going up ten teeth on the rear actually do?
Do I need a longer chain?
Should I replace the chain at the same time?
Will shorter gearing hurt my range?
How do I know a part fits my bike?
What if it does not fit?
About Drivetrain
Gearing is the cheapest big change you can make to an electric dirt bike, and the easiest one to get wrong. A bigger rear sprocket adds hill torque and low-end pull and takes top speed away in the same proportion; a smaller one does the reverse. Nothing here changes how much power the motor makes, only where it puts it. Run the numbers on the gearing calculator before you buy, or read the 48T vs 58T breakdown for the Light Bee.
Sprockets here are cut from 7075-T6 and hard anodized, in 420 pitch to match the stock chain on Surron and Talaria. Chains are pre-stretched and O-ring sealed so they hold adjustment instead of needing a tug every ride. Tensioners use sealed bearings for the same reason.
Every part shows which bikes it is verified for. Chain slack is set at the tightest point in the suspension travel, not on the stand; the chain care guide covers the 30-second wear check.
Change the ratio, change the bike.
Free US shipping over $99. Every sprocket names the frames it fits.
Shop drivetrain
