Drivetrain
for Talaria Sting MX3
Drivetrain verified to fit the Talaria Sting MX3 (60V 38Ah). Every part below carries the TMX3 fitment tag, checked before it ships. See everything for the Talaria Sting MX3.
Verified FitAll Emoto 58 Tooth Upgraded Sprocket
Verified FitWarp 9 E-Moto Sprocket
Verified FitSprocket for Sur-Ron And Talaria Sting
Verified FitChain Cover Aluminum for Talaria MX3 MX4
Chain care: tension, slack, and a 30 second wear check
The cheapest part on the bike takes the most abuse and gets the least attention. A chain that is too tight eats...
Read the guide →
Verified FitDirtyBike Talaria Sting MX3/MX4 Chain Guide Kit
Verified FitChain Cover for Talaria X3 MX3 MX4
Verified FitDirtyBike Aluminum Rear Sprocket
Verified FitWarp 9 EK 420SH E-Moto Chain
Gearing Calculator
Pick a sprocket combo and see top speed, torque change and chain length before you spend anything.
Run your numbers →
Verified FitWarp 9 E-Moto Titanium Sprocket Bolts
Verified FitDirtyBike Talaria Sting MX3/MX4 Titanium Rear Axle
Chain iron for Talaria Sting
Rear Sprocket for Sur-Ron Light Bee
Verified FitDirtyBike Aluminum Axle Blocks
Verified FitDirtyBike 420 Final Drive X-Ring Chain
Verified FitDirtyBike Replacement Slider Chain Guide
Drivetrain questions, answered
What does going up ten teeth on the rear actually do?
Do I need a longer chain?
Should I replace the chain at the same time?
Will shorter gearing hurt my range?
How do I know a part fits my bike?
What if it does not fit?
About Drivetrain
Gearing is the cheapest big change you can make to an electric dirt bike, and the easiest one to get wrong. A bigger rear sprocket adds hill torque and low-end pull and takes top speed away in the same proportion; a smaller one does the reverse. Nothing here changes how much power the motor makes, only where it puts it. Run the numbers on the gearing calculator before you buy, or read the 48T vs 58T breakdown for the Light Bee.
Sprockets here are cut from 7075-T6 and hard anodized, in 420 pitch to match the stock chain on Surron and Talaria. Chains are pre-stretched and O-ring sealed so they hold adjustment instead of needing a tug every ride. Tensioners use sealed bearings for the same reason.
Every part shows which bikes it is verified for. Chain slack is set at the tightest point in the suspension travel, not on the stand; the chain care guide covers the 30-second wear check.
Change the ratio, change the bike.
Free US shipping over $99. Every sprocket names the frames it fits.
Shop drivetrain
