Drivetrain
for MotoTec Mud Monster XL 212cc 2 Seat Go Kart
Drivetrain verified to fit the MotoTec Mud Monster XL 212cc 2 Seat Go Kart . Every part below carries the MONSTE212 fitment tag, checked before it ships. See everything for the MotoTec Mud Monster XL 212cc 2 Seat Go Kart.
Verified FitMotoTec Mud Monster XL 212cc Go Kart Sprocket Hub and Shaft 25T-#420
Fits your bike
Verified Fit
Verified Fit
Verified FitMotoTec Mud Monster XL 212cc Go Kart Primary Torque Converter Clutch Assembly
Fits your bike
Chain care: tension, slack, and a 30 second wear check
The cheapest part on the bike takes the most abuse and gets the least attention. A chain that is too tight eats...
Read the guide →
Verified Fit
Verified FitMotoTec Mud Monster XL 212cc Go Kart Secondary Torque Converter Clutch Assembly
Fits your bike
Verified Fit
Verified FitMotoTec Mud Monster Go Kart Rear Sprocket 65T
Fits your bikeGearing Calculator
Pick a sprocket combo and see top speed, torque change and chain length before you spend anything.
Run your numbers →
Verified Fit
Verified Fit
Verified FitMotoTec Mud Monster XL 2000w - Motor/Gearbox/Axle Assembly
Fits your bike
Verified FitMotoTec Mud Monster XL 212cc Go Kart Axle Sprocket Adaptor
Fits your bike
Verified FitMotoTec Mud Monster XL 212cc Go Kart Axle Sprocket #420-25T
Fits your bike
Verified FitMotoTec Mud Monster XL 212cc Go Kart 10 Tooth Sprocket
Fits your bike
Verified FitMotoTec Mud Monster XL 212cc Go Kart Torque Converter Belt
Fits your bike
Verified Fit
Verified FitDrivetrain questions, answered
What does going up ten teeth on the rear actually do?
Do I need a longer chain?
Should I replace the chain at the same time?
Will shorter gearing hurt my range?
How do I know a part fits my bike?
What if it does not fit?
About Drivetrain
Gearing is the cheapest big change you can make to an electric dirt bike, and the easiest one to get wrong. A bigger rear sprocket adds hill torque and low-end pull and takes top speed away in the same proportion; a smaller one does the reverse. Nothing here changes how much power the motor makes, only where it puts it. Run the numbers on the gearing calculator before you buy, or read the 48T vs 58T breakdown for the Light Bee.
Sprockets here are cut from 7075-T6 and hard anodized, in 420 pitch to match the stock chain on Surron and Talaria. Chains are pre-stretched and O-ring sealed so they hold adjustment instead of needing a tug every ride. Tensioners use sealed bearings for the same reason.
Every part shows which bikes it is verified for. Chain slack is set at the tightest point in the suspension travel, not on the stand; the chain care guide covers the 30-second wear check.
Change the ratio, change the bike.
Free US shipping over $99. Every sprocket names the frames it fits.
Shop drivetrain